Thermador PODC302 User Manual - Page 27
Service - problems
![]() |
View all Thermador PODC302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Service Before Calling Service Troubleshooting Chart Oven Problem Oven door is locked and will not open, even after cooling. Oven is not heating. Oven is not cooking evenly. Baking results are not as expected. Food takes longer to cook than expected. Food is overcooked. Convection Bake/True Convection results are not as expected. Oven temperature is too hot or too cold. Oven light is not working properly. Oven light does not turn off. Cannot remove lens cover on light. Oven is not self-cleaning properly. Clock and timer are not working properly. "E" and a number appears in display and control beeps. With a new oven there is a strong odor when oven is turned on. Control does not react when a key is touched. Possible Causes and Suggested Solutions Turn the oven off at the circuit breaker and wait five minutes. Turn breaker back on. The oven should reset itself and will be operable. Check circuit breaker or fuse box to your house. Make sure there is proper electrical power to the oven. Be sure oven temperature has been selected. Refer to cooking charts for recommended rack position. Check "Getting the Most Out of Your Appliance" for tips and suggestions. Refer to cooking charts for recommended rack position. Check "Getting the Most Out of Your Appliance" for tips and suggestions. Adjust oven calibration if necessary. See "Oven Temperature Offset" under "User Settings". The oven is carefully calibrated to provide accurate results. However, the temperature can be offset if food is consistently too brown or too light. See "Oven Temperature Offset" under "User Settings". The oven is carefully calibrated to provide accurate results. However, the temperature can be offset if food is consistently too brown or too light. See "Oven Temperature Offset" under "User Settings". The oven temperature must be manually reduced by 25 ºF. Refer to cooking charts and tips for rack positions, cooking times and pan selection. Adjust oven calibration if necessary. See "Oven Temperature Offset" under "User Settings". The oven thermostat needs adjustment. See "Oven Temperature Offset" under "Special Features". Replace or reinsert the light bulb if loose or defective. Touching the bulb with fingers may cause the bulb to burn out. Check for obstruction in oven door. Check to see if hinge is bent. There may be soil build-up around the lens cover. Wipe lens cover area with a clean dry towel prior to attempting to remove the lens cover. Allow the oven to cool before running self-clean. Always wipe out loose soils or heavy spillovers before running self-clean. If oven is badly soiled, set oven for the maximum self-clean time. Make sure there is electrical power to oven. This is a fault code. Press "+" and "-" simultaneously to stop beeping and clear display. Reset oven if necessary. If fault code remains, record fault code, cancel oven and call authorized service technician. This is normal with a new oven and will disappear after a few uses. Operating the self-clean cycle also "burns-off" the smell more quickly. Be sure that pad is clean. Touch the center of the touchpad. Use the flat part of your finger. English 24
![](/manual_guide/products/thermador-podm301-user-manual-ce53bb1/27.png)