Tripp Lite SV20KM1P1B Owners Manual for SmartOnline 208V SV-Series 3-Phase Mod - Page 26

9. Control Panel SmartOnline SV-Series UPS Operating Mode Standby Bypass Line Battery Battery Test Fault Converter ECO Output Voltage Y Y Bypass Voltage Range Y Y Y Y Y Y Y Y Bypass Frequency Range Y Y Converter Mode Y ECO Mode Y Y Y Bypass Mode Y Y Auto Restart Y Y Y Y Y Y Y Y Cold Start Y Y Y Y Y Y Y Y Battery Mode Delay Time Y Y Y Y Y Y System Shutdown Time Y Y Y Y Y Y Y Y System Restore Time Y Y Y Y Y Y Y Y Redundancy Y Y Y Y Y Y Y Y Charger Test Y Y Y Y Y Y Y Y Table 9.4 9.3.6.3 Battery The SETUP - BATTERY screen may be accessed in any UPS operating mode. Some settings may only be amended in certain modes; refer to table 9.5 for details. Battery Capacity in Ah Set battery capacity (0-999) (Default: 009) BATTERY BATTERY CAPACITY IN Ah MAXIMUM CHARGING CURRENT BATTERY LOW / SHUTDOWN SETTING BATTERY TEST BATTERY AGE ALERT TEMPERATURE COMPENSATION Maximum Charging Current Battery Low Voltage Battery Low Capacity Battery Shutdown Voltage Periodic Battery Test Battery Test Interval Stop by Time Stop by Battery Voltage Stop by Battery Capacity Battery Age Alert Temperature Compensation Set maximum battery charging current (1-64A) (Default: 2 for UPS system) Set battery low voltage: (10.5-11.5V) x (number of batteries) (Default: 110V) Set battery low capacity (20-50%) (Default: 20%) Set voltage point for system shutdown (10-11V) x (number of batteries) (Default: 100) Set 'Disable' or 'Enable' (Default: Disabled) Set battery test interval (7-99 days) (Default: 30) Set testing time for battery test (10-1000 sec) (Default: 10) Set battery voltage cut-off to end battery test (11-12V) x (number of batteries) (Default: 110V) Set battery capacity cut-off for battery test (20-50%) (Default: 20) Set battery age for replacement alert (Disable, 12-60 months) (Default: Disable) Set battery compensation (-5 ~ 0) (Default: 0) 26