Tripp Lite SV20KM1P1B Owners Manual for SmartOnline 208V SV-Series 3-Phase Mod - Page 27

9. Control Panel Battery Capacity in Ah Standby Y SmartOnline SV-Series UPS Operating Mode Bypass Line Battery Battery Test Y Y Fault Converter ECO Y Y Y Maximum Charging Current Y Y Battery Low Voltage Y Y Y Y Y Y Battery Low Capacity Y Y Y Y Y Y Battery Shutdown Voltage Y Y Y Y Y Y Periodic Battery Test Y Y Y Y Y Y Y Y Battery Test Interval Y Y Y Y Y Y Y Y Stop by Time Y Y Y Y Y Y Y Stop by Battery Voltage Y Y Y Y Y Y Y Stop by Battery Capacity Y Y Y Y Y Y Y Battery Age Alert Y Y Y Y Y Y Y Y Temperature Compensation Y Y Y Y Y Y Y Y Table 9.5 9.3.6.4 Pre-Alarm The SETUP - PRE-ALARM screen may be accessed in any UPS operating mode. All settings may be made in any operating mode. PRE-ALARM Line Voltage Range Line Frequency Range Load Set line voltage range. Upper limit: +5/10/15/20%; lower limit: -5/10/15/20% (Default: +15/-20%) Set line frequency range. Upper limit: +1/2/3/4 Hz; lower limit: -1/2/3/4 Hz (Default: +/-4%) OVERLOAD: Set UPS overload (40-100%) (Default: 100%) LOAD UNBALANCE: Set output load unbalance (20-100%) 9.3.7 Information Screen Use Down/Right key to select "INFORMATION" option. Press "Enter" key to enter Information sub-menu. Identification HOME MENU INFORMATION System Battery The Information screens offer an overview of all the programmed UPS system states. A summary is provided below. Identification Data Model Name Serial Number Display#ID Firmware Version STS# xx Firmware Version Module#ID DSP Firmware Version Module#ID MCU Firmware Version Module#ID Serial Number User Adjustable / Section Reference No No No No No No No Note: Module information may repeat depending on number of power modules installed. 27