Viking VSOT Use and Care Manual - Page 7
Grounding Instructions, Service, Power Connections, Self-Cleaning Oven Guidelines, RF Interference
View all Viking VSOT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Getting Started IMPORTANT - Please Read and Follow! Grounding Instructions Service • Should this appliance require service, please call Viking Range, LLC at 1-888-(845-4641). A qualified service representative will assist you and if required, coordinate a service visit by an authorized service agent in your area. Power Connections • To avoid potential hazards, only the manufacturer, its service agent, or a similarlyqualified person should replace a damaged power cable. Flexible conduit, conductors and connectors are supplied by the manufacturer. The oven must be connected using the flexible conduit and conductors provided. Self-Cleaning Oven Guidelines • Clean the oven only in accordance with the guidelines provided on page 49. • Before self-cleaning the oven, remove broiler pan, grid, racks, and other cookware. Clean only parts listed in manual. • Listen for fan-a fan noise should be heard during the self-cleaning cycle. If not, call Viking Range, LLC at 1-888-(845-4641) before self-cleaning again. • DO NOT clean the door gasket. The door gasket is essential for a good seal. DO NOT to rub, damage, or move the gasket. • DO NOT use oven cleaners. No commercial cleaner or oven liner protective coating of any kind should be used in or around any part of the oven. Residue from oven cleaners will damage the inside of the oven when the selfclean mode is used. • In the event the oven is malfunctioning in the self-clean mode, turn the oven off or disconnect it from the power supply and call Viking Range, LLC at 1-888-(845-4641). • Complete instructions on the operation of the self-clean mode can be found on page 49. RF Interference Considerations • The appliance has been tested and was determined to be in compliance with applicable portions of FCC part 18 requirements and with the protection requirements of Council Directive 89/336/ EEC on the approximation of the laws of the European Union Member States relating to electromagnetic compatibility at the time of manufacture. However, some equipment with sensitivity to signals below these limits may experience interference. • If any equipment experiences interference, the following steps should be considered: o Increase the physical distance between the sensitive equipment and this oven. o If the sensitive device can be grounded, do so following accepted grounding practices. o If battery-powered microphones are being affected, ensure that the batteries are fully charged. o Keep sensitive equipment on separate electrical circuits if possible. o DO NOT route intercom wires, microphone wires, or speaker cables near the oven. SAVE THESE INSTRUCTIONS 7