Yamaha 9000Pro Owner's Manual - Page 164

The 9000Pro "Functions" Harmony/Echo Settings The explanations here apply to step #3 of the Basic Procedure on page 158. Quick Guide on page 35 Select a Harmony type. See below for details. Set the volume of the Harmony effect. Assign the Harmony effect to the various parts as listed below. Determines the lowest velocity value at which the harmony note will sound. The higher the value, the harder the keyboard must be played to apply the Harmony effect. When set to ON, the Harmony effect is applied only to the note that belongs to a chord played on the left side of the keyboard from the split point. This setting is not available when the Multi Assign, Echo, Tremolo, or Trill type is selected. Adjust the speed of the echo/tremolo/trill effect. This parameter is active when any of the echo-based effects are selected (15 through 17). I About the Harmony types • When a Harmony type ("STANDARD DUET" through "STRUM") is selected Split Point A chord played on the left side of the keyboard from the split point controls the harmony. This type automatically adds one or more harmony notes to a single-note melody played on the right side of the keyboard from the split point. • When "MULTI ASSIGN" is selected Multi Assign automatically assigns notes played simultaneously on the right-hand section of the keyboard to separate parts (voices). The number of parts which can be assigned depends on the number of parts turned ON via the [PART ON/OFF] buttons. If three parts are turned on, then up to three voices can be assigned. if two parts are turned on, then only two voices can be assigned. For example, if the R1, R2, and R3 parts are turned on and you play and hold three successive notes, the first note will be played with the R1 voice, the second note with the R2 voice, and the third note with the R3 voice. • When "ECHO" is selected An echo effect is applied to the note played on the keyboard at the currently set tempo. • When "TREMOLO" is selected A tremolo effect is applied to the note played on the keyboard at the currently set tempo. • When "TRILL" is selected Two notes held on the keyboard are played alternately at the currently set tempo. I About "ASSIGN" • R1 Harmony is only applied to the R1 part. If R1 is OFF there will be no Harmony effect. • R2 Harmony is only applied to the R2 part. If R2 is OFF there will be no Harmony effect. • R3 Harmony is only applied to the R3 part. If R3 is OFF there will be no Harmony effect. • AUTO Harmony notes are automatically assigned to the R1, R2, and R3 parts, in that order or priority. • MULTI Multi Assign automatically assigns the 1st, 2nd, and 3rd added harmony notes to separate parts (voices). For example, if the R1, and R2 parts are turned on and the STANDARD DUET type is selected, then the note you play on the keyboard will be played by the R1 voice, and the added harmony note will be played by the R2 voice. • For all voices except Organ Flutes and Plug-in voices, if you change the chord in your left hand while holding down a note with your right hand, the pitch of the harmony note(s) will bend (without attack) to match the newly played chord. When using Organ Flutes or Plug-in voices with your right hand, the harmony note(s) is retriggered with a fresh attack at a new pitch matching the newly played chord. • The echo, tremolo, and trill effects set via the Harmony/ Echo function may not affect the Organ Flutes sound and the Plug-in voice as expected. 164 Reference 162