Yamaha DVX-S100 Owner's Manual - Page 16
Installing the speakers, Placing the center speaker, Placing the front and rear, speakers
View all Yamaha DVX-S100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
SPEAKER SETUP Installing the speakers I Placing the center speaker Place the speaker on TV whose top is flat or on the floor under the TV or inside the TV rack so that it is stabilized. When placing the speaker on top of the TV, to prevent the speaker from falling down, put the provided fasteners at four points on the bottom of the speaker and the top of the TV. I Mounting the front and rear speakers When mounting the front and rear speakers on a wall, use the holes on the speakers' back panels. 1 Put the provided pads at the four corners on the rear of the front and rear speakers to prevent the front and rear speakers from moving by vibrations. Fastener Peel off the seal 2 Fasten screws into a firm wall or wall support as shown below. Cautions • Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. If placed, the speaker may drop out causing an injury to you. • Do not place the speaker on top of the TV with an inclination. • Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength. • Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop. I Placing the front and rear speakers When placing the front and rear speakers on a flat surface, attach the included non-skid pads to the corners on the bottom of the speakers as shown below. This prevents the speakers from sliding around. Diam. 3.5 to 4 mm Min. 20 mm 6 mm Tapping screw (Available at the hardware store) Non-skid pads 12