Yamaha DVX-S100 Owner's Manual - Page 71
Appendix, Troubleshooting, General
View all Yamaha DVX-S100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
TROUBLESHOOTING Refer to the chart below when this unit does not function properly. If the problem you are having is not listed below or if the instruction below does not help, set this unit to the standby mode, disconnect the power cord, and contact the nearest authorized YAMAHA dealer or service center. I General Problem Cause This unit fails to turn on when STANDBY/ ON (or POWER ( )) is pressed, or enters in the standby mode soon after the power has been turned on. No sound. The power cord is not connected or the plug is not completely inserted. This unit has been exposed to a strong external electric shock (such as lightning and strong static electricity). Incorrect input or output cable connections. An appropriate input source has not been selected. The speaker connections are not secure. The volume is turned down. The sound is muted. The picture does not appear. The source that this unit cannot reproduce, such as a CD-ROM, is being played. The output and input for the picture are connected to different types of video jacks. The sound suddenly goes off. Only the speaker on one side can be heard. Sound can be heard only from the front speakers. The sleep timer has functioned. Incorrect cable connections. The sound effect is off. A Dolby Surround, Dolby Digital or DTS decoding DSP program is being used with material not encoded with Dolby Surround, Dolby Digital or DTS. A 96-kHz sampling digital signal is being input to this unit. Remedy Firmly connect the power cord. Refer to page - Set this unit in the standby mode, disconnect the power cord, plug it back in after 30 seconds, then start operating. Connect the cables properly. If the problem persists, the cables may be defective. Select an appropriate input source with the input selector buttons. Secure the connections. Turn up the volume. Press MUTE or any operation buttons of this unit to cancel a mute and adjust the volume. Play a source whose signals this unit can reproduce. Make connections using the same type of video jacks (S VIDEO or VIDEO (composite)) for both the input and output. Turn on the power, and play the source again. - 14 - 19 21 17 - 18 21 21 - 14 22 Connect the cables properly. If the problem persists, the cables may be defective. 17 - 18 Press STEREO to turn it on. Select another DSP program. 27 23 - 24 When a 96-kHz sampling digital signal is being 27 input to this unit, sound is output from the front speakers only. APPENDIX English 67