Yamaha DVX-S100 Owner's Manual - Page 61
Remote Control Features, Operating Other Components Using The Remote Control - remote control replacement
View all Yamaha DVX-S100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
REMOTE CONTROL FEATURES OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL Setting the manufacturer code (remote control signal assigned to each manufacturer) for your TV, VCR or MD/ CD recorder on the remote control allows you to operate not only the DVX-S100 but also your TV, VCR or MD/ CD recorder using the remote control. Note • Depending on the model, certain components from other manufacturers cannot be controlled, or only limited functions can be controlled, even though the proper manufacturer code has been set. If you encounter this problem, please use the remote control supplied with the component. Setting the manufacturer code Manufacturer codes can be set for TV, VCR and MD/ CD-R buttons only. Note • TV manufacturer codes can be set for the TV button only. However, any of the manufacturer codes can be set for the VCR and MD/CD-R buttons. TV CODE SET POWER TV AV SLEEP POWER TV MODE INPUT CH VOL MUTE SUBTITLE AUDIO REC TUNER MD CD-R VCR VIDEO 2 VIDEO 1 CODE SET SHIFT CD DVD AMP HALL JAZZ ROCK ENTERTAINMENT 1 2 3 4 SETUP ANGLE SPORTS MONO MOVIE MOVIE 1 MARKER MOVIE 2 5 6 7 8 /DTS PLAY MODE REPEAT SELECT MATRIX 6.1 9 0 >-10 TOP MENU LEVEL GROUP MENU SET MENU PRESET ABCDE A-B STEREO CANCEL PAGE MUTE CH CH ENTER PRESET TEST ON SCREEN B. BOOST RETURN VOL AV MD/CD-R VCR Numeric buttons 2 Keeping CODE SET pressed, enter the 1- digit device code and the 2-digit manufacturer code for the component to be controlled using the numeric buttons. You can release CODE SET after entering the code. y • The manufacturer code 99 has been set for the remote control selector buttons (TV, VCR and MD/CD-R) at the factory. 3 Press POWER (TV or AV) and check that the component to be controlled turns on and off (standby). Precautions when performing the setting You can operate the component using the TV, VCR or MD/CD-R operation buttons on the remote control once the manufacturer code is set properly. If unsuccessful, perform the procedure from step 1 again. Pay attention to the following points when you perform the procedure. • Check that the correct remote control selector button has been selected when setting the manufacturer code. • If more than one code is given for a manufacturer, try entering each code in the order given. • Remove and replace the remote control's batteries (complete this step within 2 minutes) and then perform the procedure. While replacing the batteries, be sure not to press any button on the remote control. Doing so may erase the manufacturer code which has been set for other remote control selector buttons. To reset the manufacturer code to the factory-set code Follow steps 1 to 2 for the procedure "Setting the manufacturer code", and enter the device code for the component and "99" while pressing CODE SET in step 2. (It is not necessary to follow step 3.) (U.S.A. model) 1 While pressing CODE SET, press the input selector button (TV, VCR, MD/CD-R) for which the manufacturer code is to be set. Only one manufacturer code can be set for each input selector button. Note • Keep pressing CODE SET between step 1 and 2. • Refer to "LIST OF MANUFACTURER'S CODES" at the end of this manual. English 57