Yamaha PSR-SX600 PSR-SX600 Reference Manual - Page 105
Connecting with a Smart Device via Wireless LAN, Infrastructure Mode
View all Yamaha PSR-SX600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Connecting with a Smart Device via Wireless LAN By using a USB wireless LAN adaptor (sold separately), you can connect the PSR-SX600 with a smart device via a wireless network. For general operating instructions, refer to the "Smart Device Connection Manual" on the website. This section covers only operations that are specific to the PSR-SX600. Before starting operations, make sure the USB wireless LAN adaptor is connected to the [USB TO DEVICE] terminal and call up the setup display via [MENU] → TAB [F] Menu2 → Cursor buttons [][][E][F] Wireless LAN → [ENTER]. NOTICE Do not connect this product to public Wi-Fi and/or Internet directly. Only connect this product to the Internet through a router with strong password-protections. Consult your router manufacturer for information on security best practices. NOTE If the USB wireless LAN adaptor is not recognized by the instrument, "Wireless LAN" is not shown. When "Wireless LAN" is not shown even though a USB wireless LAN adaptor has been connected, turn the instrument off, and then on again. When the connection is successful, "Connected" is shown at the top of the display, and an icon indicating the signal strength appears at the right of each available connection. Infrastructure Mode [1 ]/ WPS [2 ] [3 ] [4 ] Mode Detail [5 ]/ [6 ] [7 ]/ [8 ] Initialize Connect Connects this instrument to the network via WPS. Press this button followed by the [7 ] (Yes) button, then, press the WPS button on your access point within two minutes. 9 Switches to the Access Point Mode. Connections For setting the detailed parameters. After making these settings, press one of the [7 ]/[8 ] (Save) button to actually save them. IP ADDRESS: Sets the IP address and other related parameters. OTHERS: Sets the Host name, Time Zone and Daylight Saving Time. When the instrument is connected to the network with the Infrastructure Mode, the current time is shown on the Main display. Initializes the connection setup to the default factory status. Use the Cursor buttons [][] to select the network. Pressing one of the [7 ]/[8 ] buttons connects to the selected network. If you select "Others," this calls up the Manual Setup display in which you set the SSID, security method, and password. After entering those, press one of the [7 ]/[8 ] buttons in the Manual Setup display to connect to the network. NOTE Pressing the TAB [E] and [F] buttons simultaneously updates the network list on the display. PSR-SX600 Reference Manual 105