Yamaha RX-V563 Owner's Manual - Page 27
Setting the speaker impedance, Turning on and off the power, Turning on this unit - receiver
UPC - 027108929972
View all Yamaha RX-V563 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
PREPARATION Connections Setting the speaker impedance Caution If you are to use 6 ohm speakers, set "SP IMP." to "6Ω MIN" as follows BEFORE using this unit. 1 Press CSYSTEM OFF on the front panel to set this unit to the standby mode. Refer to the right column for details. 2 Press and hold NTONE CONTROL and then press AMAIN ZONE ON/OFF to turn on this unit. This unit turns on, and the advanced setup menu appears in the front panel display. TONE CONTROL While holding down MAIN ZONE ON/OFF 3 Press OPROGRAM l / h to select "SP IMP.". "SP IMP." and the current speaker impedance setting ("8Ω MIN") appear in the front panel display. Turning on and off the power ■ Turning on this unit Press AMAIN ZONE ON/OFF (or HPOWER) to turn on this unit. y When you turn on this unit, there will be a 4 to 5-second delay before this unit can reproduce sound. ■ Set this unit to the standby mode Press AMAIN ZONE ON/OFF (or ISTANDBY) to set this unit to the standby mode. In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control. y You can set the main zone and zone 2 to the standby mode simultaneously by pressing CSYSTEM OFF. 4 Press PSTRAIGHT repeatedly to select "6Ω MIN". 5 Press AMAIN ZONE ON/OFF to save the new setting and turn off this unit. Note The setting you made is reflected next time you turn on this unit. English 23 En