ZyXEL P-335U User Guide - Page 54

P-334U/P-335U User's Guide Table 10 Wizard Step 2: Basic(WEP) Security LABEL DESCRIPTION Key 1 to Key 4 The WEP keys are used to encrypt data. Both the ZyXEL Device and the wireless stations must use the same WEP key for data transmission. If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters ("0-9", "A-F"). If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters ("0-9", "A-F"). If you chose 256-bit WEP, then enter 29 ASCII characters or 58 hexadecimal characters ("0-9", "A-F"). You must configure at least one key, only one key can be activated at any one time. The default key is key 1. Back Click Back to display the previous screen. Next Click Next to proceed to the next screen. Exit Click Exit to close the wizard screen without saving. 3.3.2 Extend(WPA-PSK or WPA2-PSK) Security Choose Extend(WPA-PSK) or Extend(WPA2-PSK) security in the Wireless LAN setup screen to set up a Pre-Shared Key. Figure 21 Wizard Step 2: Extend(WPA-PSK or WPA2-PSK) Security The following table describes the labels in this screen. Table 11 Wizard Step 2: Extend(WPA-PSK or WPA2-PSK) Security LABEL Pre-Shared Key Back Next Exit DESCRIPTION Type from 8 to 63 case-sensitive ASCII characters. You can set up the most secure wireless connection by configuring WPA in the wireless LAN screens. You need to configure an authentication server to do this. Click Back to display the previous screen. Click Next to proceed to the next screen. Click Exit to close the wizard screen without saving. 54 Chapter 3 Connection Wizard