1998 Chevrolet Express Van Owner's Manual - Page 16

Replacing the Rear Seat A CAUTION: A seat thatisn't locked into place properly can move around in a collision or sudden stop. People in the vehicle could beinjured. Be sure tolock the seat into place properly when installing it. 2. Position the seat into the open slots in both rails. Push the seat forward in the rail, hooking both seat bases onto the pins inside of the rails. 3. Both locking pins that locked the into place seat must be installed before operating the vehicle. 4. To install the locking pin at the rear of the seat base, pull the carpet/mat flap back on the inboard side to locate the hole in the rail for the pin. 1 A CAUTION: - - A safety belt that twistedor not properly is attached won't provide the protection needed in a crash. The person wearing the belt could be seriously injured. After installing the seat, always check to be sure that the safety belts are not twisted and are properly attached. 1. Remove the trim covers from the floor rails and store for future use. 5. Remove the pin from its stowed position on the seat base while holding the carpedmat flapback.