2012 Subaru Forester Owner's Manual - Page 118

1-10 Seat, seatbelt and SRS airbags To lower: Push the head restraint down while pressing the release button on the top of the seatback. To remove: While pressing the release button, pull out the head restraint. To install: Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks. When the rear-center seating position is occupied, raise the head restraint to the extended position. When the rear center seating position is not occupied, lower the head restraint to improve rearward visibility. & Reclining the seatback (if equipped) CAUTION If the vehicle is equipped with a cargo area cover, observe the following precautions. . Be careful not to pinch your hand between the head restraint and the cargo area cover when you recline the rear seat. . Move the front cover of the cargo area cover backward so that the cover is not damaged by the reclined seatback. Refer to "Cargo area cover (dealer option)" F6-14. WARNING To prevent the passenger from sliding under the seatbelt in the event of a collision, always put the seatback in the upright position while the vehicle is in motion. Also, do not place objects such as cushions between the passenger and the seatback. If you do so, the risk of sliding under the lap belt and of the lap belt sliding up over the abdomen will increase, and both can result in serious internal injury or death. Push the switch and adjust the seatback to the desired position. Then release the switch and make sure