2012 Subaru Forester Owner's Manual - Page 273
2012 Subaru Forester Manual
Page 273 highlights
Audio 5-17 & Station preset ! How to preset stations 1. Press the "FM/AM" button to select the preferred reception mode. 2. Select the preferred station. 3. Press and hold one of the preset buttons (from to ) for more than 1.5 seconds to store the frequency. If the button is pressed and held for less than 1.5 seconds, the preceding selection will remain in memory. 2. Press the preferred preset button (from to ) briefly. ! Auto-store (type D audio) Using the Auto-store function, you can automatically store 6 stations on the current waveband (FM-AS or AM-AS) by pressing and holding the button for 1.5 seconds or longer. Use Auto-store to quickly find the strongest stations, for example when traveling through different reception areas. dial - Pressing the "SCAN" button ! Displaying and selecting preset stations (type D audio) 1. Press and hold the button for 1.5 seconds or longer during AM/FM reception to display the radio screen. 2. Operate the "TUNE/TRACK/CH" dial to select the stations. NOTE . Up to six stations for each reception mode may be preset. . If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all stations stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset buttons. . If a cell phone is placed near the radio, it may cause the radio to emit noise when it receives calls. This noise does not indicate a radio malfunction. ! Selecting preset stations 1. Press the "FM/AM" button to select the preferred reception mode. NOTE . When the HD Radio function is turned on, Auto-store cannot be used while receiving the broadcasting station with SPS (Supplemental Program Service). . When you use Auto-store, the new stations replace any stations previously stored. . Interrupting Auto-store: If you accidentally press the (Auto-store) button, you can cancel the Auto-store function before it has been completed as follows. - Switching to the other source mode - Pressing the button - Switching to the other band - Turning the "TUNE/TRACK/CH"