2012 Subaru Forester Owner's Manual - Page 299

Audio 5-43 that is used, the screen on the cell phone may remain illuminated while the ignition switch is in the "ON" position. If this occurs, turn the illumination off by adjusting the cell phone settings. . Depending on the setting of the cell phone, the dial lock function may be activated after making a call. Deactivate the automatic dial lock function of the cell phone before using the Handsfree system. . Depending on the type of cell phone that is used, operation and the sound volume may be different from those of cell phones currently used. . When the ignition switch is turned to the "LOCK" position during a call, the call may be disconnected or continued on the cell phone depending on the type of cell phone that is used. Note that operation of the cell phone may be necessary if the call is continued on the cell phone. . Do not speak at the same time as the other party during a call. If you and the party speak at the same time, it may be difficult for the other party to hear your voice and vice versa. This is normal. . The receiver sound volume should be set as low as possible. Otherwise, the party you are calling may notice an undesirable echo sound. . Speak clearly and loudly. . Your voice may be difficult to be heard by the party under the following conditions. - Driving on a rough road. - Driving at a high speed. - Driving with a window open. - When air from the ventilator blows directly towards the microphone. - When the sound coming from the ventilator is loud. - When the cell phone is too close to the microphone. . The sound quality may degrade due to the influence of the cell phone that is connected to the system or the circumstances of the Bluetooth network. . When another Bluetooth® device is simultaneously connected, noise may be heard in the voice coming from the hands-free phone. ! Corresponding profiles for the cell phone . HFP (Hands Free Profile): Ver. 1.0 . OPP (Object Push Profile): Ver. 1.1 & Certification for the Handsfree system CAUTION FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user 's authority to operate the equipment. NOTE This device complies with Part 15 of the FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment - CONTINUED -