Adaptec 2074700-R User Guide - Page 65
Installation of ICPCON Monitoring Utility
View all Adaptec 2074700-R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Installing Linux 5.5.2 5.6 5.6.1 Further Driver Parameters disable:Y deactivates the RAID driver disable:N activates the RAID driver reserve_mode:0 reserves no SCSI devices [*1] reserve_mode:1 reserves all not-initialized removable hard disk [*1] reserve_mode:2 reserves all not-initialized SCSI devices [*1] reserve_list:h,b,t,l,h,b,t,l,... reserves SCSI devices at the corresponding coordinates with h=Hostadapter, b=SCSI Bus, t=Target ID, l=LUN reverse_scan:Y reversed scanning order of the PCI controllers reverse_scan:N Normal scanning order of PCI controllers according to the system BIOS max_ids:x x = number of target IDs per SCSI channel (accelerates the boot process) rescan:Y rescan all SCSI channels / Ids rescan:N scan only those SCSI devices found during system power up [*1] • The driver parameters reserve_mode and rescan:N require ICP RAID controllers with firmware version FW x.23.00 or higher. • The current default settings of the driver are: 'gdth=disable:N,reserve_mode:1,reverse_scan:N,max_ids:127,rescan:N' • If gdth is loaded as a module, these parameters can also be added with a special syntax. • IRQ parameters are entered as 'IRQ=' (for example, IRQ=10). Several parameters are not separated with a comma (',') but a space (' '). All ':' are substituted with '=', all 'Y' with '1' and all 'N' with '0'. • Default: 'modprobe gdth disable=0 reserve_mode=1 reverse_scan=0 max_ids=127 rescan=0' Installation of ICPCON Monitoring Utility Installation of ICPCON from the RAID Software Suite CD-ROM 1. If you are installing the ICPCON from the RAID Software Suite CD-ROM, then place the RAID Software Suite CD-ROM in the CD-ROM drive and mount the CD-ROM: $ mount /dev/cdrom /mnt/cdrom 2. Copy the ICPCON utility archive to /usr/sbin. Note that x.xx in these examples is the version of ICPCON that was shipped on your software CD that matches the current Firmware. $ cp /mnt/cdrom/linux/install/storcon-2.02.gz /usr/sbin/storcon-x.xx Software Installation and User's Guide 65