Brother International KE-436C Instruction Manual - English - Page 19
Installing the belt cover, 3-16. Installing the foot switch
View all Brother International KE-436C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
3. INSTALLATION 3-15. Installing the belt cover 1. Loosen the screws (2) of the upper cover (1). 2. Insert the belt cover (3) in the direction of the arrow, and then secure it with the two screws (2) and the two screws (4). Check that the cords do not get clamped by the belt cover at this time. * It is not necessary to remove the belt cover (3) when tilting back the machine head. 3-16. Installing the foot switch 2456Q [A] 2507Q [B] 2683Q 2508Q 1. Insert the connector of the foot switch (3) into the connector (2) of the control box (1). 2. Install the foot switch (3) to the work table leg (12) with foot switch support plate A (4), foot switch support plate C (5), the bolt (6), spring washer (7), flat washer (8), bolt (9), spring washer (10) and flat washer (11) as shown in Figure A. If foot switch support plate B (13) is used in a back-to-front position, it can be used as shown in Figure B. 1. Remove the screw (14) and rubber plug (15). * Note that the spring (16) will come out when the screw (14) is removed. 2. Turn foot switch support plate B (13) back to front, and then install it with the bolt (17), spring washer (18) and flat washer (19) as shown in Figure B. Note: If using the foot switch without installing it to the work table leg, move the foot switch at least 10 mm away from the leg. If the foot switch is not fully in contact with the work table leg when the foot switch is used, for example, if it is just hooked loosely onto the work table leg, it may cause the sewing machine to operate incorrectly. 13 KE-436C