Brother International KE-436C Instruction Manual - English - Page 61

11. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES Memory switches (30 - 3F) Turn the dial while pressing the STEP BACK switch to change the values. Switch No. memo-30 memo-31 memo-32 memo-33 memo-34 memo-35 Possible setting range 1 - 999 1 - 5 3 - 7 1 - 10 1 - 5 3 - 9 Units × 10ms − − × 7.5° stitch × 100rpm Initial value 10 4 3 5 1 4 Explanation Time until feed mechanism starts moving after work clamp has lifted. Changes the feed speed. 1 (Fast) ←→ 5 (Slow) Changes the possible sewing speed for a given stitch length. 3 (Fast) ←→ 7 (Slow) 3 (2,500/3 mm), 4 (2,300/3 mm), 5 (2,000/3 mm), 6 (1,800/3 mm), 7 (1,200/3 mm) Changes the feed timing. 1 (Fast) ← 5 (Standard) → 10 (Slow) Number of low-speed stitches sewn at 400 rpm at sewing start. Changes the sewing start speed for the number of stitches specified by memo-34. memo-36 − − − − memo-37 0 - 3 Automatically corrects the gear speed when reading 2DD disks. 0: No automatic correction − 0 1: Read as BAS-311A data 2: Read as BAS-326A data 3: Read as BAS-341A, 342A data ex. Read BAS-326A data by KE-436C → Set memo-37=2. memo-38 − − − − memo-39 0 - 11 Changes the reference point for enlargement and reduction using the operation panel. 0, 1: Center of work clamp, 2: Upper-left corner of work clamp, 3: Lower-left corner of work clamp, − 0 4: Upper-right corner of work clamp, 5: Lower-right corner of work clamp, 6: Sewing start point, 7: Sewing end point, 8: Upper-left corner of sewing pattern, 9: Lower-left corner of sewing pattern, 10: Upper-right corner of sewing pattern, 11: Lower-right corner of sewing pattern memo-3A 1 - 3 Changes the speed limit for the given sewing pitch when the maximum speed remains constant. 1: Speed limit is increased for the given sewing pitch and the sewing speed for that pitch is increased. 2: Standard − 2 3: Speed limit is decreased for the given sewing pitch and the sewing speed for thet pitch is decreased. Note: If sewing slippage occurs in places where a large sewing pitch is used, reduce the setting to 3. Furthermore, sewing slippage may occur in some cases if setting 1 is used. memo-3b 0 - 13 Changes the work clamp operating mode. (When set to "0", − 0 the mode is selected according to the settings for DIP switches A-1 and A-2.) Refer to "12. Setting the work clamp mode" for details on the setting values. memo-3c 0 - 4 Changes the path taken when moving from the machine − 0 home position to the start position. 0: Across inside of work clamp, 1: Top-left, 2: Bottom-left, 3: Bottom-right, 4: Top-right memo-3d − − − − memo-3E − − − − memo-3F − − − − 55 KE-436C