Brother International NX-600 Users Manual - English - Page 25
that the spring on the shaft fits into the notch, in the bobbin.
View all Brother International NX-600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES Turn on the sewing machine. a Place the spool of thread for the bobbin onto f the spool pin. Slide the spool onto the pin so that the spool is horizontal and the thread unrolls from the bottom front of the spool. Lift open the upper cover. b Place the bobbin on the bobbin winder shaft so c that the spring on the shaft fits into the notch in the bobbin. 1 • If the spool is not positioned so that the thread unrolls correctly, the thread may become tangled around the spool pin. Slide the spool cap onto the spool pin. g With the rounded side of the spool cap positioned toward the left, slide the spool cap onto the spool pin as far as possible until the right side of the spool touches the right end of the spool pin. 2 a Notch b Bobbin winder shaft spring Slide the bobbin winder shaft to the right. d • Three spool cap sizes are available (large, medium and small). Use the spool cap with a diameter that is slightly larger than the diameter of the spool. The medium-sized spool cap is already on the spool pin when the sewing machine is purchased. 1 2 APPENDIX Remove the spool cap that is inserted onto the e spool pin. 1 2 a Spool pin b Spool cap 3 a Spool cap (large) b Spool cap (medium) c Spool • When using a spool of cross-wound thread, install the small spool cap with some space between the cap and the spool. 1 2 3 a Spool b Gap c Spool cap (small) Winding/Installing the Bobbin 19 INDEX