Brother International NX-600 Users Manual - English - Page 94
Zipper/piping Insertion, Inserting a centered zipper - driver
View all Brother International NX-600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
UTILITY STITCHES CONTENTS Zipper/piping Insertion A zipper and piping can be sewn in place. Stitch Name Pattern Stitch Key Application Straight stitch 1 (left needle position) Attaching zippers Sewing concealed seams and piping Stitch Width [mm (inch.)] Auto Manual 0.0 0.0-7.0 (0) (0-1/4) Stitch Length [mm (inch.)] Auto Manual Presser Foot 2.5 0.2-5.0 (3/32) (1/64-3/16) There are many methods for inserting zippers and pipings. The procedures for inserting a centered zipper and a piping are described below, with the adjustable zipper/piping foot. Inserting a centered zipper Slide the presser foot over either the left or e right feed dog. Refer to step - a d of "Inserting a centered a zipper" (page 83). Remove the presser foot and presser foot b holder (page 39) to attach the screw-on adjustable zipper/piping foot. GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX Note z Use a screw driver to securely tighten the screw that holds the presser foot. If the screw is loose, the needle may break and cause injures. Select stitch 1 . c Loosen the positioning screw on the back of d the presser foot. Left sewing position Right sewing position Change the needle position so that the needle f does not touch the presser foot. For details, refer to "Adjusting the stitch width" (page 55). 1 a Needle drop point CAUTION ● After adjusting the needle position, slowly turn the balance wheel toward you and check the needle does not touch the presser-foot. If the needle hits the presser foot, the needle may bend or break. 1 a Positioning screw 88 INDEX