Canon PIXMA MP950 MP950 User's Guide - Page 141

„ Slow scanning speed Cause Resolution is set higher than necessary. Image correction features such as dust and scratch reduction, fading correction, and descreening are enabled in ScanGear MP. Action To view the image on a monitor, set the output resolution to 75 dpi. To print, set the output resolution to a value such as 300 dpi. Set [Reduce Dust and Scratches], [Fading Correction], and [Descreen] to [OFF] in the [Image Settings] section of the Advanced Mode of ScanGear MP. „ "There is not enough memory." message is displayed Cause There is not enough memory to continue scanning. Action Exit any application software that are running, and try to run this software again. „ Scanned image not displayed properly Cause Scanned image prints out enlarged (reduced). Action Set the printing size in the application software. Example: ArcSoft PhotoStudio 1. With the image in the selected state, click the [File] menu and select [Print]. 2. Move the print size slider left or right in the Print dialog to adjust the printing size. The preview image to the left will change size accordingly. Scanned image enlarged (reduced) z Change the display setting in the application software. on the computer monitor. z Images opened in [Paint] or [Imaging] may be displayed in full size and you may not be able to reduce its display size. Open the image in an application software supplied with the scanner instead. Refer to the onscreen manual for each application software for the detailed procedures. z Change the resolution setting in the scanner driver and rescan. The higher the resolution, the larger the resulting image will be. z Some application software do not display clear images at small image display settings. Set the scale to 100%. Chapter 12 Troubleshooting 139