Casio QT 6000 Service Manual - Page 32
DIAG command input system, 4. Status Display, However, when performing a test
View all Casio QT 6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
7-3. DIAG command input system Input a command according to the following code. XXXXXXn a g d XXXXXX : additional action n : number of times a : action g : group d : device number 7-4. Status Display With the EX820, the following display is displayed on the LCD (SVGA). (In this DIAG, the display area is divided into a display for register entry and a display of DIAG results and so forth. DALLAS DRW1 CLOSE 0000 MENU SHEET 1 DRW2 CLOSE CLR ESC 7 8 9 4 5 6 1 2 3 0 ST [Functions] Status is displayed for those devices having status information. The devices and status displayed are as shown below. Device Status Information (Displayed Information) Dallas key Dallas key no. Dallas key 2 Drawer Dallas key no. Open/close status MAC address MAC address CF Insertion status DISP ON/OFF switch Switch status TEMP Poxwer supply A/D conversion value * Display only updated when DISP ON/OFF switch is ON [LCD Display] MAC ADRS XX-XX-XX-XX-XX-XX CF INSERT DISP ON/OFF ON TEMP 20 Status information is displayed continuously (in ordinary characters). However, when performing a test, the status at completion of a test is displayed following completion of that test. Diag Ver : XXXXXX XXXX DALLAS DRW1 CLOSE 0000 DRW2 CLOSE 1234 Register: Characters enlarged 1.5 times (max. 10 digits) Counter display * Addition of TEMP information and DISP ON/OFF status The TEMP status is acquired preferentially when the DISP ON/OFF switch is ON. When measuring other status information or when starting each test mode, always make sure to begin after switching off the DISP ON/OFF switch. - 30 -