Cisco ATA188-I2-A Administration Guide - Page 108

Operational Parameters Chapter 5 Parameters and Defaults Table 5-4 SigTimer Parameter Bit Definitions Bit Number 0-7 8-13 14-19 20-25 26-27 28-31 Definition Call waiting period-The period between each burst of call-waiting tone. Range: 0 to 255 in 0.1 seconds Default: 100 (0x64=100 seconds) Reorder delay-The delay in playing the reorder (fast busy) tone after the far-end caller hangs up. Range: 0 to 62 in seconds Default-5 (seconds) 63-Never play the reorder tone. Ring timeout-When a call is not answered, this is the amount of time after which Cisco ATA rejects the incoming call. Range-0 to 63 in 10 seconds Default-6 (60 seconds) 0-Never times out Not used by H.323. Minimum hook flash time-The minimum on-hook time required for hook flash event. Range: 0 to 3 Default: 0 (60 ms) Other possible values: 1=100 ms, 2=200 ms, 3=300 ms. Maximum hook flash time-The maximum on-hook time allowed for hook flash event. Range: 0 to 15 Default: 0 (1000 ms) Other possible values: 1=100 ms, 2=200 ms, 3=300 ms, 4=400 ms, 5=500 ms, 6=600 ms, 7=700 ms, 8=800 ms, 9=900 ms, 10=1000 ms, 11=1100 ms, 12=1200 ms, 13=1300 ms, 14=1400 ms, 15=1500 ms. ConnectMode Description This parameter is a 32-bit bitmap used to control the connection mode of the selected call signaling protocol. Table 5-5 on page 5-33 provides bit definitions for this parameter. Value Type Bitmap Default 0x00060400 Voice Configuration Menu Access Code 311 5-32 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0) OL-4804-01