Cisco ATA188-I2-A Administration Guide - Page 147
Call Command Behavior
View all Cisco ATA188-I2-A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
Chapter 6 Call Commands Call Command Behavior Call Command Behavior Table 6-4 summarizes differing Call Command behavior based on the U.S. and Sweden default call commands. U.S. Call Command Default Af;AH;BS;NA;CS;NA;Df;EB;Ff;EP;Kf;EFh;HH;Jf;AFh;HQ;I*67;gA*82;fA#90v#;OI;H#72v#;bA#74 v#;cA#75v#;dA#73;eA*67;gA*82;fA*70;iA*69;DA*99;xA;Uh;GQ; Sweden Call Command Default BS;NA;CS;NA;Df;EB;Ff0;ARf1;HPf2;EPf3;AP;Kf1;HFf2;EFf3;AFf4;HQh;HH;Jf1;HFf2;EFf3;AFf4; HQ;Af4;HQ;I*31#;gA#31#;gA*90*v#;OI;H*21*v#;bA*61*v#;dA*67*v#;cA#21#;eA#61#;eA#67#;e A*31#;gA#31#;gA*43#;hA#43#;iA*69#;DA*99#;xA;Uh;GQ; Table Notations The following notations are used in Table 6-4: • FE-Far end • AFE-Active Far End, which is a connected far end that is not placed on hold • WFE-Waiting Far End, which is a connected far end being placed on hold, or an incoming caller waiting to be answered • R-Hook Flash • ONH-On Hook • OFH-Off Hook • 0-9,*,#-DTMF digits • v-a variable length string, usually a phone number, and does not include # • CWT-call-waiting tone Note The notations in Table 6-4 include abbreviations for input sequence behavior. Refer to the tables and syntax examples shown earlier in this section. The Summary of Commands column in Table 6-4 is based on the actual command syntax used in the default Call Command strings for the United States and Sweden. Table 6-4 Call Command Behavior Cisco ATA State and its Definition Summary of Commands (Input Sequence and Actions) IDLE: Phone is on-hook; Cisco ATA is waiting for incoming call • OFH-Start dial tone and go to PREDIAL state. • New incoming call or a waiting call (started before it enters IDLE)-Start ringing the phone and go to the RINGING state. PREDIAL: Phone just went off-hook but United States and Sweden: no DTMF has been entered yet; Cisco ATA plays dial-tone • # , *-Stop dial-tone, go to the CONFIG state, and prepare to accept a complete configuration sequence. • 0-9: Stop dial tone, start invoking dial-plan rules, and go to the DIALING state to accept a complete phone number. OL-4804-01 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0) 6-7