Cisco ATA188-I2-A Administration Guide - Page 197

Appendix A Using H.323 Supplementary Services Common Supplementary Services Making a Conference Call in Sweden Procedure Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Dial the first number. When the person you called answers, press the flash or receiver button on the telephone handset. This will put the first person you called on hold and a dial tone will sound. Dial the second person and speak normally when that person answers. Perform a hookflash, then press 2 on your telephone keypad to return to the first person. You can continue to switch back and forth between the two callers. To conference with both callers at the same time, perform a hookflash, then press 3 on the telephone keypad. Once you conference all three callers, the only way to drop a caller is for that caller to hang up. (Optional) To conference in additional callers, the last person called with a Cisco ATA can call an additional person, that new person can call someone else, and so on. This is known as "daisy-chaining." Call Waiting in the United States If someone calls you while you are speaking on the telephone, you can answer by performing a hook flash. You cannot conference in all three callers, but the first person you called could call someone else and daisy-chain them into the conference. When the Cisco ATA is configured to use Call Waiting by default, press *70 on your telephone keypad to disable Call Waiting for the duration of the next call. Call Waiting in Sweden If someone calls you while you are speaking on the telephone, you can answer by performing a hookflash then pressing 2 on your telephone keypad, or you can conference them with the person to whom you are already speaking by performing a hookflash then pressing 3. You can also perform a hookflash then press 3 later during the call to create a conference call. Performing a hookflash then pressing 1 hangs up the first caller and answers the second call. If there is no answer after one minute, the caller receives three beeps and a busy signal. To enable call waiting for Sweden, press *43#. When the Cisco ATA is configured to use Call Waiting by default, press #43# to disable Call Waiting for the duration of the next call. Calling Line Identification Presentation Calling Line Identification Presentation (CLIP) shows your identity to callers with Caller ID. Press *82 on your telephone keypad to activate CLIP. OL-4804-01 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0) A-3