Cisco ATA188-I2-A Administration Guide - Page 123

Chapter 5 Parameters and Defaults Tone Configuration Parameters Table 5-7 Reorder Tone Parameter Example 1 Explanation (continued) Component NumOfRepeats TotalToneTime Setting 0 0 Explanation First on-off pair of the cadence plays once (does not repeat), then the second on-off pair plays Tone plays continuously (set of three on-off pairs of the cadence repeat continuously) until another call event stops the tone ReorderTone Parameter Example 2 Assume that you want a reorder tone in which: • The only frequency is 400 Hz. • The frequency plays six times, each time for 0.1 second followed by 0.9 second of silence. • The frequency then plays once for 0.3 second followed by 0.7 second of silence. • The volume of the frequency is -19 dBm. • The tone plays until another call event stops the tone. For this reorder tone, make the following setting. See Table 5-8 for a detailed explanation. ReorderTone:100,1,31164,1620,0,0,0,0,2,800,7200,2400,5600, 0,0,5,0 Table 5-8 Reorder Tone Parameter Example 2 Explanation Component Sequential NumOfFreqs TFreq1 TAmp1 TFreq2 TAmp2 TFreq3 TAmp3 NumOfOnOffPairs OnTime1 OffTime1 OnTime2 OffTime2 OnTime3 OffTime3 Setting 100 1 31164 1620 0 0 0 0 2 800 7200 2400 5600 0 0 Explanation Required setting for a tone with one frequency One frequency in the tone First frequency is 400 Hz First frequency volume is -19 dBm No second frequency No second frequency No third frequency No third frequency Two on-off pairs in the cadence of the tone Sound in first on-off pair plays for 0.1 second Sound in first on-off pair is followed by 0.9 second of silence Sound in second on-off pair plays for 0.3 seconds Sound in second on-off pair is followed by 0.7 second of silence No third on-off pair in the cadence No third on-off pair in the cadence OL-4804-01 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0) 5-47