Cisco ATA188-I2-A Administration Guide - Page 109
Bit Number, Definition, μ-law/G.711 A-law.
View all Cisco ATA188-I2-A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Chapter 5 Parameters and Defaults Operational Parameters Table 5-5 ConnectMode Parameter Bit Definitions Bit Number 0 1 2 3 4 5 6 7 8-12 13 14-15 Definition 0-Use slow-start procedure (for H.225/Q.931 and H.245). 1-Use fast-start procedure (for H.225/Q.931). Default: 0 0/1-Disable/enable h245 tunneling. Default: 0 0-Use the dynamic payload type 126/127 as the RTP payload type (fax pass-through mode) for G.711 µ-law/G.711 A-law. 1-Use the standard payload type 0/8 as the RTP payload type (fax pass-through mode) for G.711 µ-law/G.711 A-law. Default: 0 0-Do not perform full gatekeeper registration when the Cisco ATA switches to an alternate H.323 gatekeeper. 1-Perform full gatekeeper registration when the Cisco ATA switches to an alternate H.323 gatekeeper. Default: 0 0-Denotes a non-Cisco CallManager environment. 1-Enable the Cisco ATA to operate in a Cisco CallManager environment. Default: 0 0/1-Enable/disable two-way cut-through of voice path before the Cisco ATA receives the CONNECT message. Default: 0 0/1-Disable/enable using the Progress Indicator to determine if ringback is supplied by the far end with RTP. Default: 0 0/1-Disable/enable fax pass-through redundancy. Default: 0 Specifies the fax pass-through NSE payload type. The value is the offset to the NSE payload base number of 96. The valid range is 0-23; the default is 4. For example, if the offset is 4, the NSE payload type is 100. 0-Use G.711µ-law for fax pass-through codec. 1-Use G.711A-law for fax pass-through codec. Default: 0 0-Use fax pass-through. 1-Use codec negotiation in sending fax. 2-Reserved. 3-Reserved. Default: 0 OL-4804-01 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0) 5-33