Cisco ATA188-I2-A Administration Guide - Page 122

Tone Configuration Parameters Chapter 5 Parameters and Defaults Two examples of Extended Format B, both using the Reorder tone, follow. ReorderTone Parameter Example1 Assume that you want a reorder tone in which: • The frequencies 900 Hz, 1400 Hz, and 1800 Hz play sequentially. • Each frequency plays once for 0.33 seconds. • There is no silence after the first and the second frequencies. • There is 1 second of silence after the third frequency (before the first frequency starts again) • The volume of each frequency is -19 dBm. • The tone plays until another call event stops the tone. For this reorder tone, make the following setting. See Table 5-7 for a detailed explanation. ReorderTone:101,3,24917,3405,14876,4671,5126,5178,3,2640,0,2640,0, 2640,8000,0,0 Table 5-7 Reorder Tone Parameter Example 1 Explanation Component Sequential NumOfFreqs TFreq1 TAmpl1 TFreq2 TAmp2 TFreq3 TAmp3 NumOfOnOffPairs OnTime1 OffTime OnTime2 OffTime2 OnTime3 OffTime3 Setting 101 3 24917 3405 14876 4671 5126 5178 3 2640 0 2640 0 2640 8000 Explanation Frequencies play sequentially Three frequencies in the tone First frequency is 900 Hz First frequency volume is -19 dBm Second frequency is 1400 Hz Second frequency volume is -19 dBm Third frequency is 1800 Hz Third frequency volume is -19 dBm Three on-off pairs in the cadence of the tone Sound in first on-off pair plays for 0.33 seconds No silence after the first sound (the second sound plays immediately) Sound in second on-off pair plays for 0.33 seconds No silence after the second sound (the third sound plays immediately) Sound in third on-off pair plays for 0.33 seconds 1 second of silence after the sound in the third on-off pair (before the pattern repeats, beginning with the first on-off pair) 5-46 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0) OL-4804-01