Cisco ATA188-I2-A Administration Guide - Page 136
DialPlanEx, IPDialPlan, Diagnostic Parameters
View all Cisco ATA188-I2-A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Diagnostic Parameters Chapter 5 Parameters and Defaults DialPlanEx If your dial plan exceeds 199 characters, then use must use the DialPlanEx parameter to configure your dial plans. The DialPlanEx parameter supports dial plans up to 499 characters in length. This range in the number of characters is the only difference between the DialPlanEx and DialPlan parameters. Therefore, all the information about the DialPlan parameter applies to the DialPlanEx parameter. For more information, see the "DialPlan" section on page 5-52. Note If you are not using this parameter for dial plan configuration, be sure this parameter is set to 0. IPDialPlan Description This Iparameter allows for detection of IP-like destination address in DialPlan. Three values are valid: • 0-String is dialed as is and not treated as an IP address. • 1-When the Cisco ATA detects two asterisks (**), IPDialPlan takes over. The user enters the pound (#) key to terminate the digit collection, and the interdigit timeout default is not used. • 2-When IPDialPlan is set to 2, three asterisks (***) are required for IPDialPlan to take effect. All other values are currently undefined. Value Type Integer Range 0, 1 or 2 Default 1 Voice Configuration Menu Access Code 310 Diagnostic Parameters This section describes the following parameters, which are used for diagnostic purposes: • NPrintf, page 5-61 • SyslogIP, page 5-61 • SyslogCtrl, page 5-62 5-60 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0) OL-4804-01