Cisco CP-7961G-GE Administration Guide - Page 108
Device > Phone > Phone Configuration
View all Cisco CP-7961G-GE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Device Configuration Menu Chapter 4 Configuring Settings on the Cisco Unified IP Phone Table 4-19 Network Configuration Menu Options (continued) Option Description To Change LLDP-MED: SW Port Enables and disables Link Layer Discovery Protocol Media Endpoint Discovery (LLDP-MED) on the switch port. Use this setting to force the phone to use a specific discovery protocol, which should match the protocol supported by the switch. Settings include: From Cisco Unified Communications Manager Administration, choose Device > Phone > Phone Configuration. • Enabled-default • Disabled LLDP Asset ID Identifies the asset ID assigned to the phone for inventory management. From Cisco Unified Communications Manager Administration, choose Device > Phone > Phone Configuration. Wireless Headset Hookswitch Control Enables users to receive notifications of incoming From Cisco Unified Communications Manager calls and answer or end calls while working in a Administration, choose Device > Phone > wireless environment. Phone Configuration. LLDP Power Priority Advertises the phone's power priority to the switch, enabling the switch to appropriately provide power to the phones. Settings include: From Cisco Unified Communications Manager Administration, choose Device > Phone > Phone Configuration. • Unknown-default • Low • High • Critical IP Addressing Mode Displays the IP addressing mode that is available From Cisco Unified Communications Manager on the phone-IPv4 only, IPv6 only, or IPv4 and Administration, choose Device > Device IPv6. Settings > Common Device Configuration. IP Preference Mode Control Indicates the IP address version that the phone uses during signaling with Cisco Unified Communications Manager when both IPv4 and IPv6 are both available on the phone. From Cisco Unified Communications Manager Administration, choose Device > Device Settings > Common Device Configuration. Displays one of the following options on the phone: • IPv4-The dual-stack phone prefers to establish a connection via an IPv4 address during a signaling event • IPv6-The dual-stack phone prefers to establish a connection via an IPv6 address during a signaling event. 4-36 Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP) OL-21011-01