DIRECTV R10 System Manual - Page 107
Enter the search code., Test the remote control.
View all DIRECTV R10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Remote Control Settings 2. Enter the search code. Refer to the table below and use the number keys on your remote control to enter the appropriate code. To Test: Enter: TV power, volume, and muting 0999 TV input 0999 A/V receiver power, volume, and mute 1999 A/V receiver volume and mute only 1999 After you press the fourth digit of the code, the red light on the end of the remote control will flash twice, then remain on. 3. Test the remote control. Point the remote control at the TV or A/V receiver. Press CHAN UP. The test is successful if the TV or A/V receiver responds (by powering off, changing input, or muting, depending on the function you are trying to program). If there is no response, wait two or three seconds, then press CHAN UP again. Continue doing this until the TV or A/V receiver responds. When the TV or A/V receiver does respond, press ENTER to select the current code. 6 The red light at the end of the remote control will flash three times to indicate that the remote control is properly programmed to control your device. When the red light on the end of the remote control turns off, you have reached the end of the available codes. Unfortunately, due to the great variety of TVs and A/V receivers, some makes and models are not compatible with your DVR's remote control. If you reach the end of the available codes without finding a code that works with your device, you will need to use your TV or A/V receiver's remote to turn those devices on and off, and to control the volume. DIRECTV Central Messages & Setup Settings Remote Control 97