Dell 1350cnw Color Laser Printer User's Guide - Page 207

*1 Enter 5 in Sleep to put the printer in the Sleep mode five minutes after it finishes a job. This uses less energy, but requires more warm-up time for the printer. Enter 5 if your printer shares an electrical circuit with room lighting and you notice lights flickering. Select a high value if your printer is in constant use. In most circumstances, this keeps the printer ready to operate with minimum warm-up time. Select a value between 5 and 30 minutes for the Sleep mode if you want a balance between energy consumption and a shorter warm-up period. The printer automatically returns to the standby mode from the Sleep mode when it receives data from the computer. You can also return the printer to the standby mode by pressing any button on the operator panel. *2 The default for mm/inch and Default Print Paper Size vary depending on countryspecific factory default. Paper Density Purpose: To specify the paper density. Values: Plain Normal* Specifies the paper density of plain paper. Light Label Normal* Specifies the paper density of labels. Light Apply New Settings After you complete the settings, press the Apply New Settings button to apply the changes. Restart printer to apply new Press the Restart printer to apply new settings button settings to apply the changes. Adjust BTR Purpose: To specify the optimum voltage settings for printing for the transfer roller (BTR). To lower the voltage, set negative values. To increase, set positive values. The default settings may not give the best output on all paper types. If you see mottles on the print output, try to increase the voltage. If you see white spots on the print output, try to decrease the voltage. Understanding the Tool Box Menus 203