Dell B2360DN Mono Laser User Guide - Page 73

Understanding the printer menus Use Run Initial setup Yes No Paper Sizes US Metric Timeouts Sleep Mode Disabled 1-120 min Timeouts Hibernate Timeout Disabled 1 hour 2 hours 3 hours 6 hours 1 day 2 days 3 days 1 week 2 weeks 1 month Timeouts Hibernate Timeout on Connection Hibernate Do Not Hibernate Timeouts Screen Timeout 15-300 sec 73 To Run the setup wizard. Notes: • Yes is the factory default setting. • After completing the setup wizard by selecting Done at the country or region selection screen, the default becomes No. Specify the unit of measurement for paper sizes. Notes: • US is the factory default setting. • The initial setting is determined by your country or region selection in the initial setup wizard. Set the amount of time the printer waits after a job is printed before it goes into a reduced power state. Notes: • "30 min" is the factory default setting. • "Disabled" appears only when Energy Conserve is set to Off. • Lower settings conserve more energy, but may require longer warm‑up times. • Select a high setting if the printer is in constant use. Under most circumstances, this keeps the printer ready to print with minimum warm‑up time. Set the amount of time the printer waits before it enters Hibernate mode. Notes: • "Disabled" is the factory default setting in all countries except European Union countries and Switzerland. • "3 days" is the factory default setting for all European Union countries and Switzerland. Set the printer to Hibernate mode even if there is an active Ethernet connection. Note: "Do Not Hibernate" is the factory default setting. Set the amount of time in seconds the printer waits before the it returns to a ready state. Note: "30 sec" is the factory default setting.