Dell PowerConnect 6248 Configuration Guide - Page 86
Con Router A, OSPF Configuration-Stub Area and NSSA Area
View all Dell PowerConnect 6248 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
AS-1 AS-2 Area 1 (0.0.0.1) - Stub IR (5.3.0.0) Area 0 (0.0.0.0) - backbone 10.2.3.3/24 3000:2:3::/64 VLAN 6 Router A - backbone (3.3.3.3) 10.3.100.3/24 3000:3:100::/64 VLAN 12 ASBR (5.1.0.0) VLAN 10 10.1.2.2/24 3000:1:2::/64 eui64 Router B - ABR (5.5.5.5) 10.2.4.2 3000:2:4::/64 VLAN 17 VLAN 5 10.2.3.2 3000:2:3::/64 IR (5.4.0.0) Area 2 (0.0.0.2) - NSSA Figure 4-4. OSPF Configuration-Stub Area and NSSA Area Configure Router A: Router A is a backbone router. It links to an ASBR (not defined here) that routes traffic outside the AS. • Globally enable IPv6 and IPv4 routing: (console) #configure ipv6 unicast-routing ip routing • Configure IP address and enable OSPF on VLAN routing interfaces 6 and 12 and enable IPv6 OSPF on the interfaces. (OSPF is enabled on the IPv4 interface in the next code group.) interface vlan 6 routing ip address 10.2.3.3 255.255.255.0 ipv6 address 3000:2:3::/64 eui64 ip ospf area 0.0.0.0 ipv6 ospf exit interface vlan 12 routing ip address 10.3.100.3 255.255.255.0 86 Routing Configuration