HP Cisco MDS 9020 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 372

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_IC_ER_TRANSFER_FILE_FAILED ) Failed to transfer file from remote node [chars]. Explanation An attempt to retrieve a file from the dumps directory has failed. Recommended Action Determine if the remote node is still online. If not, determine the problem on the remote node. If it is online, retry the CLI command or use a similar Fabric Manager procedure. Contact your customer service representative for assistance if it still fails. Cisco CLI commands may be used to access the node directly as an alternative. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_IC_EV_IOGRP_NONE_OK ) Both nodes in the IO group are not available [chars]. Explanation After the user removes the node, there were no nodes left in the I/O group. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_IC_EV_UPGRADE_NODE_PENDED ) Software upgrade process failed [chars]. Explanation A software upgrade has failed. The cause might be hardware error or it might be because of a failure in the new version of the software. An automatic software downgrade is performed to restore the nodes to their previous software version.This is indicated in the log by a "software downgrade complete" entry. If the downgrade operation fails to downgrade a node, for example because it is offline, the download operation stops and waits for the offline SAN Volume Controller to be repaired or deleted from the cluster. While the downgrade operation is in progress, configuration commands sent to the cluster fail with a message indicating that a software upgrade operation is still in progress. The downgrade operation might take up to three hours. Recommended Action 1. Display the status of the nodes on the cluster. 2. Delete any offline node from the cluster if any node is offline. If the deletion fails with a message indicating that a software upgrade is in progress, this means that the downgrade process is still active. Wait for this operation to either complete or stop on the offline node and then retry the delete. If the downgrade operation had stopped, it now continues. 3. Solve all logged hardware problems. 4. Ask the user to retry the software installation. 5. If the installation fails again, report the problem to your customer support representative. 6. Mark the error you have just repaired as fixed. Introduced Cisco MDS SAN-OS Release 1.3(1). 2-336 Cisco MDS 9000 Family System Messages Reference OL-15956-01