HP Cisco MDS 9020 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 399
init system, An attempt to copy the startup configuration to the snapshot configuration has failed
View all HP Cisco MDS 9020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 399 highlights
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message SYSMGR-2-CFGSNAPSHOT_ABORTED: Configuration snapshot aborted. Explanation An attempt to save a snapshot of the startup configuration has failed. Recommended Action Use the other syslog messages to verify that the problem has been corrected, and then try again. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message SYSMGR-2-CFGSNAPSHOT_ABORTED_DIR: Unable to open the configuration directory. Aborting configuration snapshot. Explanation The destination location for the snapshot configuration could not be found. Recommended Action If the problem persists, use the init system CLI command from the switch(boot)# prompt to initialize the configuration partition. Note: This is a disruptive command. This command will initialize the switch, reset the entire internal disk, and reformat the bootflash: partition. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message SYSMGR-2-CFGSNAPSHOT_ABORTED_INIT: Unable to initialize the configuration directory (error-id [hex]). Aborting configuration snapshot. Explanation An attempt to copy the startup configuration to the snapshot configuration has failed because the old data could not be removed. Recommended Action If the problem persists, issue the init system CLI command from the switch(boot)# prompt to initialize the configuration partition. Note: This is a disruptive command. This command will initialize the switch, reset the entire internal disk, and reformat the bootflash: partition. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message SYSMGR-2-CFGSYNC_FAILURE: Syncing of the configuration to the standby failed. Explanation A synchronization of the configuration to the standby has failed. Recommended Action Use the other system messages to verify that the problem has been corrected, and try again. Introduced Cisco MDS SAN-OS Release 2.1(1a). Error Message SYSMGR-2-CFGWRITE_ABORTED: Configuration copy aborted. Explanation A configuration copy has failed. Recommended Action Use the other syslog messages to verify that the problem has been corrected, and try again. Introduced Cisco MDS SAN-OS Release 1.2(2a). OL-15956-01 Cisco MDS 9000 Family System Messages Reference 2-363