HP Cisco MDS 9020 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 403
reload module, Cisco Systems, contact Cisco Technical Support.
View all HP Cisco MDS 9020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 403 highlights
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message SYSMGR-2-FORMAT_FAILURE_SUP_RESET: Failure to format a partition successfully causing sup to reset. Explanation The partition used to store nonvolatile persistent storage service (PSS) files could not be formatted successfully. The supervisor will be reset. Recommended Action If the problem persists, contact customer support. If you purchased Cisco support through a Cisco reseller, contact the reseller directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message SYSMGR-2-GSYNC_ABORT: Global sync aborted by signal. Explanation The initial synchronization of the services was terminated. The synchronization will be attempted again later. Recommended Action Enter the reload module CLI command or use an equivalent Fabric Manager/Device Manager procedure to reset the standby supervisor. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message SYSMGR-2-GSYNC_GET_TIMEOUT: Request for global sync for UUID [hex] not completed in specified time. Explanation Service failed to complete global sync in specified time. The standby will no longer act as a high availability standby. Recommended Action If the problem persists, contact customer support. If you purchased Cisco support through a Cisco reseller, contact the reseller directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message SYSMGR-2-GSYNC_READY_SRVFAILED: Service "[chars]" on standby supervisor failed to restore its snapshot (error-id [hex]). Explanation The initial synchronization of service failed. Recommended Action If you purchased Cisco support through a Cisco reseller, contact the reseller directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message SYSMGR-2-GSYNC_SNAPSHOT_SRVFAILED: Service "[chars]" on active supervisor failed to store its snapshot (error-id [hex]). Explanation The initial synchronization of service failed. Recommended Action If you purchased Cisco support through a Cisco reseller, contact the reseller directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support. Introduced Cisco MDS SAN-OS Release 1.2(2a). OL-15956-01 Cisco MDS 9000 Family System Messages Reference 2-367