HP Cisco MDS 9020 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 87
ETHPORT Messages, ETHPORT-3
View all HP Cisco MDS 9020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message EPP-5-EPP_LOOPBACK: Interface [chars] is looped back to the same switch. Explanation The interface is looped back to another interface on the same switch. Recommended Action Check the connectivity of this interface and ensure that it is connected to another switch. Introduced Cisco MDS SAN-OS Release 1.2(2a). ETHPORT Messages This section contains the Ethernet port (ETHPORT) messages. ETHPORT-3 ETHPORT-5 Error Message ETHPORT-3-IF_UNSUPPORTED_TRANSCEIVER: Transceiver for interface [chars] is not supported. Explanation The transceiver is not from an authorized vendor. Recommended Action Enter the show flash command or use a similar Fabric Manager/Device Manager procedure to determine which transceiver is being used. Contact customer support for a list of authorized transceiver vendors. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message ETHPORT-5-IF_DOWN_ADMIN_DOWN: Interface [chars] is down (Administratively down). Explanation The interface has been configured to be administratively down. Recommended Action Enter the show flash command or use a similar Fabric Manager/Device Manager procedure to set this interface to administratively up. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message ETHPORT-5-IF_DOWN_CFG_CHANGE: Interface [chars] is down(Config change). Explanation FCIP interface temporarily down because of a reconfiguration. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.2(2a). OL-15956-01 Cisco MDS 9000 Family System Messages Reference 2-51