HP Cisco MDS 9020 Cisco MDS 9500 Series Hardware Installation Guide (OL-17467- - Page 188
B-4, Connecting to the MGMT 10/100 Ethernet Port on the Supervisor-1 Module for
View all HP Cisco MDS 9020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
Connecting to the MGMT 10/100 Ethernet Port Chapter B Connecting the Cisco MDS 9500 Series Send documentation comments to [email protected]. Figure B-4 Connecting to the MGMT 10/100 Ethernet Port on the Supervisor-1 Module for the Cisco MDS 9500 Series 99328 MGMT 10/100 To connect the MGMT 10/100 Ethernet port to an external hub, switch, or router, follow these steps: Step 1 Step 2 Connect the appropriate modular cable to the MGMT 10/100 Ethernet port: • Use a modular, RJ-45, straight-through UTP cable to connect the MGMT 10/100 Ethernet port to an Ethernet switch port or hub. • Use a cross-over cable to connect to a router interface. Connect the other end of the cable to the device. Note For high availability, connect the MGMT 10/100 Ethernet port on the active Supervisor-1 module and on the standby Supervisor-1 module to the same network or VLAN. The active supervisor module owns the IP address used by both of these Ethernet connections. On a switchover, the newly activated supervisor module takes over this IP address. This process requires an Ethernet connection to the newly activated supervisor module. Cisco MDS 9500 Series Hardware Installation Guide B-8 OL-17467-02