HP Integrity Superdome SX1000 Windows Integrity Management Agents Reference - Page 53

Event ID Event Severity Event Description 8715 Warning There was an error initializing the LBA Probable Cause: The LBA component initialization routine failed. Recommended Action: This is an internal system firmware error. Update system firmware or contact a system firmware representative. SNMP Trap: hpevtIodiscLbaInitnodeError - 8715 in HPIFPTRAP.MIB. 8716 Error There was an error querying the LBA width Probable Cause: Error while writing the LBA phase data Recommended Action: Replace the I/O backplane SNMP Trap: hpevtIodiscLbaWidthError - 8716 in HPIFPTRAP.MIB. 8717 Warning There was an error with the LBA phase Probable Cause: Error while writing the LBA phase data Recommended Action: Replace the I/O backplane SNMP Trap: hpevtIodiscLbaPhaseError - 8717 in HPIFPTRAP.MIB. 8718 Warning There was an error clearing the LBA Probable Cause: Unable to clear an error in the LBA Recommended Action: Check other events for the error being generated replace either the PCI card or the I/O backplane SNMP Trap: hpevtIodiscLbaClearError 8718 in HPIFPTRAP.MIB. 8719 Error There was an error with the LBA log Probable Cause: The LBA component could not generate error logs. Recommended Action: This is an internal system firmware error. Update system firmware or contact a system firmware representative. SNMP Trap: hpevtIodiscLbaLogError - 8719 in HPIFPTRAP.MIB. 8720 Error There was an error discovering the LBA Probable Cause: The wrong backplane type was detected Recommended Action: replace I/O backplane SNMP Trap: hpevtIodiscLbaDiscoverError - 8720 in HPIFPTRAP.MIB. 8721 Warning There was an error configuring the LBA Probable Cause: Unable to configure the LBA Recommended Action: replace I/O backplane SNMP Trap: hpevtIodiscLbaConfigError - 8721 in HPIFPTRAP.MIB. 8722 Error There was an error scanning the PCI bus Probable Cause: Could not scan the card in a populated slot. Typically caused by an improperly installed or faulty PCI card. Recommended Action: Reseat or replace the faulty card. SNMP Trap: hpevtIodiscLbaPciscanError - 8722 in HPIFPTRAP.MIB. 8723 Error There was an error configuring PCI space through the LBA Probable Cause: Unable to obtain semaphore Recommended Action: reset Update to latest recipe SNMP Trap: hpevtIodiscLbaPciconfigError - 8723 in HPIFPTRAP.MIB. 8745 Warning The OLA cell failed accessing the complex profile Probable Cause: System firmware was unable to lock either the global or the micro semaphore. Recommended Action: Allow the OLA cell to reboot to BIB, then try the OLA operation again. Or, collect IPMI event logs and contact HP Customer Support for assistance. SNMP Trap: hpevtBootOlaCellErrAccessCmplxProfile - 8745 in HPIFPTRAP.MIB. 8747 Error Firmware was unable to find a suitable block of main memory to relocate ROM Probable Cause: Probably caused by lots of PDT entries, or no main memory present. SNMP Trap: hpevtBootFwRelocMemErr - 8747 in HPIFPTRAP.MIB. 8752 Warning Cell started OLA but is not configured in the complex profile of the partition. Probable Cause: Cell was issued an OLA command without first updating the complex profile to reflect its slot as configured in the partition. Recommended Action: Update the complex profile to include the new cell. SNMP Trap: hpevtBootOlaCellNotConfigInCmplxProfile - 8752 in HPIFPTRAP.MIB. 8756 Error The Options service received an NVRAM allocation error. Probable Cause: Invalidate NVRAM and reset. SNMP Trap: hpevtOptsNvmAllocError - 8756 in HPIFPTRAP.MIB. 8757 Warning failure on OLA cell during attempt to synch its real-time clock Probable Cause: Couldn't communicate with OLA cell. Recommended Action: Collect IPMI events and contact HP Support. SNMP Trap: hpevtBootOlaUpdateRtcFailedOlaCell - 8757 in HPIFPTRAP.MIB. 8758 Warning SAL errlog access timeout Probable Cause: Firmware is taking too long to process requests. SNMP Trap: hpevtSalInfoTimeout - 8758 in HPIFPTRAP.MIB. Platform Agent Events 53