HP P3410A HP NetRAID 1M/2M Installation & Configuration - Page 81
Step K. Install NOS-specific Configuration Utility
UPC - 725184582783
View all HP P3410A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Chapter 6 HP NetRAID Software Step K. Install NOS-specific Configuration Utility In this step, you install the configuration utility specific to your NOS. • If you are using any version of Microsoft Windows NT or Windows 2000, you install the HP NetRAID Assistant utility. This is the Windows NT and Windows 2000 version of the utility you used to configure your system in Chapter 5, "Installation and Configuration." • If you are using Novell NetWare, SCO UnixWare, or SCO OpenServer, you install the HP NetRAID Config utility. Chapter 10, "Understanding HP NetRAID Utilities," has menu maps of both of these utilities. For complete information about these utilities, see the HP NetRAID Series User Guide in Information Assistant on the HP Netserver Navigator CD-ROM. Install the utility as described for the NOS version below. Microsoft Windows NT 4.0 and Windows 2000 1. Select Start from the taskbar. 2. Choose Run from the Start menu. 3. Insert diskette #1, "NetRAID Software-NT/Win2000." 4. Type :\setup at the Open: prompt, where is the drive letter of the diskette drive you are using. 5. Follow the on-screen instructions. NOTE Setup installs the following HP NetRAID-1M or 2M software: • HP NetRAID Assistant (nraid.exe) • HP NetRAID Monitor Service (megaserv.exe) • HP NetRAID Consistency Check Scheduler (megactrl.exe) 73