HP StorageWorks 2/16V HP StorageWorks Fabric OS 4.4.0F Release Notes (AA-RW89A - Page 27
HP StorageWorks Fabric OS 4.x MIB reference guide, part number: AA-RVHXA-TE
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
HP StorageWorks Fabric OS 4.x MIB reference guide, part number: AA-RVHXA-TE On page 32, add the following section after Table 3: Firmware upgrades and enabled traps Prior to Fabric OS v4.4, traps were turned on and off as a group (for example, the SW-Trap, or FA-Trap). In these versions of the Fabric OS it was not possible to set individual traps (such as, swSensorStatusChangeTrap, swTrackChangesTrap, or connUnitEventTrap). In Fabric OS v4.4 or above you can turn on and off traps individually within a trap group. The individual traps need to be enabled explicitly after the corresponding trap group is enabled. Because the pre-Fabric OS v4.4 firmware only has trap group level settings, when you upgrade to the Fabric OS v4.4 firmware or above, individual traps are turned off by default even if the corresponding trap group was enabled before upgrading. When moving from a download version to Fabric OS v4.4 or above you must use either the snmpmibvapset or snmpconfig command to turn on explicitly the individual traps within each trap group. HP StorageWorks Fabric OS 4.x procedures user guide, part number: AA-RVHWA-TE On page 50, in the "To enable or disable RADIUS service" section; add the following Warning: WARNING! When you issue aaaConfig --radius on, all sessions in which you are logged on are logged off immediately, and local authentication is disabled. On page 81, at the end of the "Upgrading Core Switch 2/64 and SAN Director 2/128" section add the following Caution: CAUTION: To successfully download firmware to a Director you must have an active Ethernet connection on both CPs. Fabric OS 4.4.0f release notes 27