HP StorageWorks 2/16V HP StorageWorks Fabric OS 4.4.0F Release Notes (AA-RW89A - Page 34

Replace Table 12 on page 76 with the following: Table12: WWN Bezel LED Patterns LED location and purpose LED Color Status Recommended Action 16-Port card/CP Steady green card Power Flashing green Power is OK Power to port card is OK; however, this LED flashes if the port card status LED is flashing. No action required. Check port card status LED and determine if it is flashing slow (2 second increments) or fast (1/2 second increments) and then take appropriate action. No light (LED is No port card is present or the off) power source is unavailable. Insert port card, or check AC switch and power source. NOTE: Check the individual port card (see Figure 15 on page 81) or CP card power LEDs (see Figure 16 on page 85) on the port side of the chassis to confirm the LED patterns. 16-Port card/CP card Status Steady Amber Slow-flashing amber (2 seconds on; then 2 seconds off) Port card is faulty. Port card is not seated correctly or is faulty. Check port card. Pull card out and reseat it. If LED continues to flash, replace card. Fast-flashing amber (1/2 second on; then 1/2 second off) Environmental range exceeded or port card failed diagnostics (run during POST or manually). Check for out-of-bounds environmental range and correct it. Replace card if it fails diagnostics. No light (LED is Port card is either healthy or off) does not have power. Verify that the port card power LED is on. 34 Core Switch 2/64 and SAN Director 2/128 installation guide, part number: AA-RVUSC-TE