HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 66

Troubleshooting Identifying LCD-Indicated Conditions Table 3-1. Chassis Codes for J5000 and J7000 Workstations Ostat Code FLT 7207 FRU DIMM FLT 7208 DIMM INI 721s DIMM INI 722s DIMM INI 723s DIMM INI 724s DIMM INI 725s DIMM FLT 72As DIMM FLT 72Cs DIMM INI 7300 SYS BD WRN 7302 SYS BD WRN 7306 SYS BD INI 7307 SYS BD FLT 7308 SYS BD FLT 7309 DIMM FLT 730C SYS BD INI 730F SYS BD TST 7400 DIMM TST 740F DIMM INI 7500 SYS BD WRN 7501 SYS BD FLT 7502 SYS BD TST 7600 DIMM Message DIMM table full no DIMMs found is DIMM s inst? ???? DIMM in s 128M DIMM in s 256M DIMM in s 512M DIMM in s DIMM s checksum DIMM s mismatch mem config start mem confg changd use alt mem conf interleve memory PDT is disabled insufficient mem mem intrlv fail mem config done non-dest mem tst non-dst tst done memory reset mem log clr warn mem err log fail dest mem test Description The DIMM table is full--cannot add new type. SPD didn't find any memory DIMMs. SPD is checking memory slot s. SPD found a DIMM in slot s, but can't determine its size. DIMM will not be used. SPD found a 128MB DIMM in slot s. SPD found a 256MB DIMM in slot s. SPD found a 512MB DIMM in slot s. DIMM in slot s failed SPD checksum and will not be used. DIMM in slot s didn't match the other in pair. (J7000 only--DIMMs must be in matched pairs.) Starting main memory configuration. Memory physical configuration changed since last boot. Memory will be configured from fixed values, instead of detected DIMMs. Generating the memory interleave. Firmware detected bad memory pages, but the Page Deallocation Table is disabled. Insufficient error-free memory to continue. Memory interleave generation failed. Main memory configuration complete. Starting non-destructive memory test. Non-destructive memory test complete. Resetting memory system. Memory error logs didn't clear on first try. Firmware could not clear memory error logs. Starting the destructive memory test. 62 Chapter 3