HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 73

Troubleshooting Identifying LCD-Indicated Conditions Table 3-1. Chassis Codes for J5000 and J7000 Workstations Ostat Code WRN C64F FRU EXT IO Message reset montr type TST C68s SYS BD test graph in s INI C68s SYS BD init graph in s WRN C68s SYS BD fail graph in s INI C740 EXT IO init other path INI C780 EXT IO ld IPL othr path WRN C7F0 EXT IO other IPL fault WRN C7F1 EXT IO bad alt IPL read WRN C7F2 EXT IO bad alt IPL read WRN C7F3 EXT IO bad alt IPL read WRN C7F4 EXT IO bad alt IPL read WRN C7F8 EXT IO bad alt IPL read WRN C7FF launch IPL other INI CB00 SYS BD TOC initiated WRN CB01 SYS BD no OS TOC vector WRN CB02 SYS BD bad OS TOC addr WRN CB03 SYS BD bad OS TOC code Description The console device failed to initialize with the given monitor type. Try again with type 1. Look for graphics card in PCI slot s. Successfully initialized graphics card in PCI slot s. Card in PCI slot s failed graphics initialization or is not a graphics card. Autoboot is trying to boot from non-primary boot device. Loading IPL from non-primary boot device. Error loading IPL from non-primary boot device. Cannot load IPL from non-primary boot device--load address invalid. Cannot load IPL from non-primary boot device--file is not IPL image. Cannot load IPL from non-primary boot device--IPL image size invalid. Cannot load IPL from non-primary boot device--IPL entry point address invalid. Cannot load IPL from non-primary boot device--IPL image checksum failed. Booting from a device other than the primary boot path. A Transfer of Control entered the firmware TOC handler. There is no TOC vector for the operating system. Firmware will soft boot the system. The operating system TOC handler vector is invalid. Firmware will soft boot the system. The operating system TOC handler is invalid. Firmware will soft boot the system. Chapter 3 69