HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 74

Troubleshooting Identifying LCD-Indicated Conditions Table 3-1. Chassis Codes for J5000 and J7000 Workstations Ostat Code WRN CB04 FRU SYS BD Message bad OS TOC len WRN CB05 SYS BD bad OS TOC chksm WRN CB0A SYS BD prev TOC logged INI CB0B SYS BD branch to OS TOC WRN CB0C SYS BD br OS TOC failed WRN CB10 SYS BD LPMC initiated WRN CB11 SYS BD icache LPMC err WRN CB12 SYS BD dcache LPMC err WRN CB13 SYS BD dcache tag error WRN CB14 SYS BD dcache data err FLT CB1F SYS BD OS LPMC failed WRN CB71 SYS BD HPMC occurred WRN CB72 SYS BD LPMC occurred WRN CB73 SYS BD TOC occurred FLT CB9r IO BD Error on roper Description The size of the operating system TOC handler is invalid. Firmware will soft boot the system. The operating system TOC handler failed the checksum test. Firmware will soft boot the system. Firmware detected unread PIM data from a previous TOC and will not overwrite it. (PIM for this TOC is lost.) Branching to the operating system TOC handler. Branch to the operating system TOC handler failed. Firmware will soft boot the system. A Low-Priority Machine Check entered the firmware LPMC handler. The handler should log the error and return to normal operation. An instruction cache parity error caused the LPMC. A data cache parity/ECC error caused the LPMC. The parity error is in the tag portion of the data cache. The parity error is in the data portion of the data cache. Firmware couldn't branch to the operating system LPMC handler. It will halt the CPU, requiring a power cycle to recover. A High-Priority Machine Check caused entry to PDCE_CHECK (the firmware trap handler). A Low-Priority Machine Check caused entry to PDCE_CHECK (the firmware trap handler). A Transfer of Control caused entry to PDCE_CHECK (the firmware trap handler). An error was detected on rope r. 70 Chapter 3