HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 69

Troubleshooting Identifying LCD-Indicated Conditions Table 3-1. Chassis Codes for J5000 and J7000 Workstations Ostat Code FLT 7890 FRU DIMM Message MBE overwrt SBE FLT 7891 DIMM dup entry in PDT FLT 7892 SYS BD PDT write error FLT 7893 SYS BD PDT is full FLT 7900 SYS BD no DMT entry FLT 7901 SYS BD no rank entry FLT 7902 SYS BD bad refrsh intvl FLT 7903 SYS BD mem intrlv fail FLT 7904 SYS BD mem reloc failed FLT 7905 SYS BD mem intrlv error FLT 79FF SYS BD mem firmware err WRN 80F3 SYS BD err rd IODC byte WRN 80F4 EXT IO boot read error WRN 80F5 EXT IO boot exec error WRN 80F6 EXT IO boot read error WRN 80F7 EXT IO boot IO error WRN 80F8 EXT IO invalid boot dev WRN 80FC EXT IO invalid boot dev INI 8800 IOCARD PCI BusWlk start INI 88r1 IOCARD PCI Rope r walk INI 8802 IOCARD PCI BusWalk done INI 8803 SYS BD PCI alloc done INI 8804 SYS BD PCI config done Description Firmware replaced a correctable memory error entry in the PDT with an uncorrectable memory error entry at the same address. The PDT already contains an entry at that address. Error adding the entry to the PDT. The PDT is full--cannot add new entry. Internal error--cannot find DIMM entry. Internal error--cannot find rank entry. Computed refresh interval is invalid. Cannot generate memory interleave. Cannot interleave with relocated range (3.75GB - 4.0GB). Undefined memory interleave failure. Internal error--never expected this to happen. Cannot read IODC from ROM or card. Cannot load IODC entry_init for boot device. Error initializing boot device. Cannot load IODC entry_io for boot device. Error detected during boot device I/O. Invalid boot device class; bad IODC? Unexpected error; bad IODC? Starting PCI bus and device discovery. Starting PCI bus and device discovery on Rope r. PCI bus and device discovery complete. Done allocating address space for PCI devices. Done configuring PCI devices. Chapter 3 65