Honeywell HNVE1 Reference Guide - Page 61
Video Termination, HNVE1 V2.1 1-Channel Encoder Reference Guide, Disable, Enable, Device Information
View all Honeywell HNVE1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
HNVE1 V2.1 1-Channel Encoder Reference Guide Figure 5-2 Device Configuration on Device Setup Tab Video Termination Video termination is supported to optimize video quality. If you are using the video loopback function, then connect the video source to the video input port to receive analog video in the output port. Set video configuration to Disable. If you are not using the video loopback function, then connect the video source to the video input port, and then set video termination to Enable. To enable the video termination option: 1. Click the Device Information tab. 2. Set Video Termination to Disable if you are using the video loopback function. OR Set Video Termination to Enable if you are not using the loopback function. 3. Click Apply. Document 800-04195 Rev B 61 11/09