Honeywell HNVE1 Reference Guide - Page 66

Encoder and Device Configuration Table 5-5 Example of PTZ Dome Preset Tour Programming Functions 'D' = Delete 'E' = Edit 'S' = Save Deletes the preset tour number entered in step 3. Returns the OSD to edit stage as described in step 5. Saves the preset tour configuration. 7. When complete, program another preset or press Esc to exit the menu. Running a Preset Tour 1. Select the PTZ Dome Setup tab, then click Run. The Preset Tour OSD appears. 2. Type the number of the desired preset tour, then press Enter. The tour should begin. To stop the preset tour, click Halt. Mimic Tours For a mimic tour, you record pan, tilt, and zoom commands. Those recorded commands are played back during the mimic tour. When a mimic tour starts, the dome performs the saved commands. You can configure 16 mimic tours of up to 120 seconds each. Configuring a Mimic Tour 1. Select the PTZ Dome Setup tab. 2. 3. Type a number for the mimic tour in the Mimic Tour Details field, then click Program. The message PROGRAM MIMIC TOUR appears over the video display. 4. Move the PTZ dome using the PTZ Control (see Figure 4-5 on page 49). The pan, tilt, and zoom commands are saved in the mimic tour. You can continue to save the commands for 120 seconds. If you want to stop saving the commands before 120 seconds are over, click Halt. After you have configured the mimic tour, the message PROGRAM MIMIC TOUR COMPLETE appears over the video display. Running a Mimic Tour 1. Select the PTZ Dome Setup tab. 2. Type the required tour in the Mimic Tour Details field, then click Run. 3. Select another option in the PTZ Dome Setup view or click the PTZ control to end the tour. Deleting a Mimic Tour 1. Select the PTZ Dome Setup tab. 2. Type the required tour in the Mimic Tour Details field, then click Delete. 3. The confirmation message Deleted Mimic Tour displays. Press Esc. 66