IBM 8479 Hardware Maintenance Manual - Page 53
Removing, support, bracket, assembly
UPC - 087944653912
View all IBM 8479 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Removing the support bracket assembly When working with some options such as hard disk drives, microprocessors, and memory modules you must first remove the support bracket assembly to access the location of the option. Complete the following steps to remove the support bracket assembly: 1. Review the information in "Before you begin" on page 40. 2. Turn off the server and peripheral devices and disconnect all external cables and power cords; then remove the side cover (see "Side cover removal" on page 42). 3. Disconnect the support bracket assembly fan cable from the connector (SYSFA1) on the system board. For the location of the fan connector, see "System board internal cable connectors" on page 38. 4. Locate the end of the support-bracket assembly near the rear of the server. Pull it out approximately 152.4 mm (6 in.). 5. Pull the front end of the support bracket assembly away from the server and place the assembly aside. To reinstall the support bracket assembly, reverse the previous steps. Installing options 45